Medium strength anaerobic adhesive for sealing hydraulic and pneumatic threads connectors up to ¾” and small pipes. To replace PTFE tapes in the sealing of gases, water, LPG, hydrocarbons, oils and other chemicals. Approved for Gas according to European norm EN 751-1 (DIN-DVGW NG-5146AU0038). Highly resistant to heat, corrosion, shocks and vibrations.
Directions for use
Loxeal Threadsealing are anaerobic resins that cure when confined between two metal surfaces in absence of air (ex. threaded joint).
Some recommendations for best results:
-Clean the threads with Loxeal Cleaner 10 and allow drying before assembling (water, oil or dirtiness prevent sealant’s full adhesion on threaded parts).
-Apply a bead of product along the entire circumference between the first and the second thread of the male in sufficient quantity to fill the entire threaded surface. For product with higher viscosity, apply a small amount on the female thread too, to ensure the correct filling of the threaded joint during assembly.
-Rotate occasionally back and forth during the manual screwing to adjust the distribution of the product on the threads.
-Once the screwing is complete, seal the joints with usual torque down by the product’s specific handling cure time.